vr-csr nodes launched with containerlab comes up pre-provisioned with SSH, SNMP, NETCONF and gNMI services enabled.
Managing vr-csr nodes#
Containers with CSR1000v inside will take ~6min to fully boot.
You can monitor the progress with
docker logs -f <container-name>.
Cisco CSR1000v node launched with containerlab can be managed via the following interfaces:
to connect to a
bash shell of a running vr-csr container:
docker exec -it <container-name/id> bash
to connect to the CSR1000v CLI
NETCONF server is running over port 830
ssh admin@<container-name> -p 830 -s netconf
Default user credentials:
vr-csr container can have up to 144 interfaces and uses the following mapping rules:
eth0- management interface connected to the containerlab management network
eth1- first data interface, mapped to first data port of CSR1000v line card
eth2+- second and subsequent data interface
When containerlab launches vr-csr node, it will assign IPv4/6 address to the
eth0 interface. These addresses can be used to reach management plane of the router.
eth1+ needs to be configured with IP addressing manually using CLI/management protocols.
Features and options#
vr-csr nodes come up with a basic configuration where only
admin user and management interfaces such as NETCONF provisioned.